FREEBORD 5

ASSEBEMLY INSTRUCTIONS

STEP 1 - Your board includes

Deck

Counter sunk mounting bolt

Round head mounting bolt

S2 height adjust screw

5 Truck

S2 Topper

S2 Base

Castor

Mounting nut

Make sure you have everything

Deck x1
FB5 Truck x2
Caster x2
S2 topper x2
S2 base X2
Counter sunk mounting bolt x20
Mounting nut x20
S2 height adjust screw x4

STEP 2 - Tools

You are going to need

Philips screwdriver
3/8” wrench -or- 10mm spanner

STEP 3 - Poke Holes

Poke holes in the grip tape

Use your screw driver, mounting bolt, or something pokey to poke 8 holes in each end of the deck

Be careful, the grip is pretty strong until it completely gives way. Make sure your hand is not behind the hole when your doing your poking.

STEP 4 - Casters

Mount your casters

Use countersunk mounting bolts to attach your casters the deck
Get all 4 screws tight-ish before tightening the bolts all the way
Make sure the logos on the casters are both facing towards the ends of the deck

STEP 5 - Trucks

Mount your trucks

Use countersunk bolts to attach the trucks to the deck
The truck needs to be installed with the pivot cups towards the ends of the deck.
Get all 4 screws tight-ish before tightening the bolts all the way

STEP 6 - Bindings

Assemble your bindings

Add the plastic binding toppers to the binding baseplates using the slot in the bottom of the topper.
Use the small silver screws to set the height of the binding toppers.

Don’t be the noob that misses the slot in the bottom of the topper. Attaching the topper to the side of the base will result in the screws immediately bending.

STEP 7 - Add Bindings

Install your bindings

Attach the bindings using countersunk bolts through the widest set of holes in the deck
The nuts need to be the the grip side of the deck

If you are worried about the direction of the graphic take note of which side you install the binding toppers on as there is a toe and heal side of the toppers.